0° PROFIBUS CONNECTOR w/ Diagnostic LEDs
Ordercode: VIPA 972-0DP30
The bus connector connects PROFIBUS user knots or complete PROFIBUS net components to the PROFIBUS line. VIPA's PROFIBUS Connectors feature an all-metal-housing, a PD/diagnosis socket, as well as a controller with 4 LED indicators for quick evaluation of PROFIBUS system faults. Each connector has switchable terminating resistors, and an integrated PG port is also available to allow convenient connection to a PC or diagnostic tool.
Features:
- Bus diagnosis via Four Diagnostic LEDs
- Clock rate up to 12 Mbit/s
- Rugged, All Metal Casing for Low Noise Interference
- Integrated PG Port
- Switchable Terminating Resistor
- EasyConn fast connection via insulation cutting clamps
- 0° (straight line) connector
| Light | Color | State | Condition |
|---|---|---|---|
| PWR | Green | ON | Power Supply is OK |
| Off | Power Supply fault | ||
| Flashing | Initial self-test | ||
| TXD | Green | Flashing | Active communication |
| Off | No communication detected | ||
| Term | Green | Off | Termination Switch is Off |
| On | Termination Switch is On | ||
| Flashing | Defective termination resistor | ||
| ERR | Yellow | Off | No errors detected |
| On | Incorrect termination or poor connection | ||
| Flashing | Signal levels are out of the defined range |
Download the PROFIBUS Connector specifications sheet
Datasheet
Replacement For:
- Siemens 6GK1 500-0FC10
- Molex/Woodhead MA9D00-42
- Molex/Woodhead 120103-5001
